Changing the Series Slide

• Turn the ATEM Controller on
  • IMPORTANT: If it was already on, you MUST turn it off then back on again so that it loads the startup state - this can be done by unscrewing the power supply from the back of the ATEM Controller and removing it for 5 seconds
• On the Mac Mini, open "ATEM Software Control"
• Go to the Media tab at the bottom
• Drag the series slide (should be a 16x9 aspect ratio - preferably 1920x1080) onto a blank slot or a slide you are replacing
• IMPORTANT: Do not replace the 6 default logo slides or the 8 test card slides - choose a blank slot or replace an old series slide instead.
• IMPORTANT: Do not send the image via social media such as Facebook Messenger, as this will result in both the resolution (size) and quality of the image being reduced.
• Go to the Switcher tab at the bottom
• Under Media Player, select the series slide from the Media drop-down
• Under the File menu, choose "Save Startup State"
  • IMPORTANT: Do not make any other changes on either the ATEM Controller or in "ATEM Software Control"
• Turn the ATEM Controller off and back on again, and ensure it loads everything as normal